System Sizing

How to Size a Home Battery Backup: A Load-Planning Primer

Published 17 November 2026 · 7-minute read

Wh

Most backup-power disappointments start with the same mistake: buying equipment before anyone has written down what it needs to power. Sizing is mostly arithmetic and honesty about your priorities. This primer walks through the logic in the order a careful planner would use it. It is general education, not a design for your specific home.

1. Decide what actually needs power

FEMA’s outage guidance starts in the same place: take an inventory of the things in your home that rely on electricity. Split that list into three tiers:

  • Critical: anything health- or safety-related, plus communication (phone charging, a radio, a router).
  • Important: refrigeration, a few lights, a fan or a furnace blower.
  • Nice to have: everything else.

A system designed for tier one and part of tier two is far smaller, cheaper and safer than one that tries to run a whole house.

2. Turn the list into watt-hours

For each device, multiply its running watts by the hours per day you expect to use it. A 10 W router running 24 hours uses about 240 Wh; four 9 W LED bulbs for 5 hours use about 180 Wh. Add the totals to get a daily energy figure. Use the nameplate or a plug-in power meter rather than guesses, and remember that some devices (refrigerators, pumps) cycle on and off.

3. Check peak and surge power separately

Energy (watt-hours) tells you how big the battery must be; power (watts) tells you how big the inverter must be. Motors can draw several times their running watts for a moment when they start. Your inverter needs to handle the largest combination of loads that could run together, including those start-up surges.

4. Convert to usable battery capacity

Battery labels show nominal capacity, but you never get all of it. Depth-of-discharge limits, inverter losses and temperature all reduce what is usable, and different chemistries tolerate deep discharge differently (see our chemistry comparison). Planners therefore divide the daily energy figure by a conservative usable fraction and then multiply by the number of days of autonomy they want.

5. Add margin, then plan the protection

Once you have a target, the rest of the design follows: cable sizes, fuses and breakers, a battery management system for lithium packs, and ventilation. The U.S. Department of Energy’s overview of balance-of-system equipment is a good reminder that batteries are only one part of the bill.

Where Last Battery fits

Last Battery’s Watt-Stacking Tradecraft Manual is built around this kind of load planning and system sizing, alongside configurations, inverters, BMS and wiring layout. If you want a structured, beginner-friendly walkthrough, read our Watt-Stacking focus area. Anything that ties into your home wiring should be reviewed by a licensed electrician.

This article is general educational information, not professional electrical advice. Follow local codes and use a licensed electrician for work on your home’s electrical system.
Go further

Learn it properly with Last Battery

The Battery Revival Guide and the Watt-Stacking Tradecraft Manual cover chemistry, sizing, wiring, BMS and safety in one beginner-friendly digital system.

View Offer
Last Battery digital guide bundle
Keep reading

More from the blog

From our network

Explore Our Other Products

Other product websites from our network. Each card opens that product’s own site.